Waeco MAGIC SAFE MS-620 Montage- Und Bedienungsanleitung Seite 50

Safety and installation instructions
Warning!
Insufficient supply line connections could result in short circuits which
– Cause cable fires
– Trigger the airbags
– Damage electronic control devices
– Cause electric functions to fail (indicators, brake light, horn, ignition,
light).
Please observe the following instructions:
When working on the following supply lines, only use insulated cable lugs, plugs
and tab sleeves.
– 30 (direct supply from positive battery terminal),
– 15 (connected positive terminal, behind the battery),
– 31 (return line from the battery, earth),
– L (indicator lights left),
– R (indicator lights right).
Do not use porcelain insulating clamps.
Use a crimping tool (see fig. 3.11, page 4) to connect the cables.
For connections which are intended to be permanent, you can solder the cable
ends together and then insulate them.
When connecting to supply line 31 (earth)
– Screw the cable to the cable lug and gear disc to the vehicle's earth bolt or
– With a cable lug and a self-tapping screw to the bodywork sheet metal.
Ensure that there is a good earth connection.
When the negative terminal of the battery is disconnected, all volatile memories in
the convenience electronics lose the stored data.
The following data must be set again, depending on vehicle equipment:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate operating
instructions.
Observe the following instructions during installation:
Secure the parts of the MAGIC SAFE installed in the vehicle in such a way that
they cannot become loose under any circumstances (sudden braking, acci-
dents) and cause injuries to the occupants of the vehicle.
When drilling, ensure that there is sufficient room for the drill head to emerege
once the hole has been made to prevent damage (see Fig. 1, page 3).
Grind all drill holes and treat them with rust-protection agent.
50
MAGIC SAFE