Using Magic Safe; Operating The Remote Control - Waeco MAGIC SAFE MS-620 Montage- Und Bedienungsanleitung

MAGIC SAFE
If the central locking is not working properly, proceed as follows:
➤
Check the electrical connection to the central locking.
➤
Check if your vehicle supports software function 4 ("Impulse duration of the door
locking function").
➤
Check which value has been set for software function 4 (see "Programming"
chapter on page 77).
8.4 Testing optical and acoustic signals
During the alarm all indicators must be switched on and the alarm siren and the sta-
tus LED must signal the alarm.
8.5 Testing the automatic reactivation
➤
Activate the alarm and then deactivate it again.
➤
Do not open a door or the bonnet or boot.
MAGIC SAFE must activate itself after approx. 90 s, without locking the doors.
8.6 Testing the remote control
➤
Test all of the switching functions with both remote controls.
If the system does not respond to a remote control unit, program the affected remote
control unit (see "Programming a new remote control" chapter on page 79).
The range of the remote control can be limited by solid metal parts and
strong electrical fields, it is usually between 10 m to 20 m.
9

Using MAGIC SAFE

9.1

Operating the remote control

The two remote control units supplied have two buttons and one LED.
No. in
Fig. 7, page 6
1
2
3
The LED flashes when you press one button or both buttons simultaneously.
Description
Button 1
Button 2
LED
Using MAGIC SAFE
69