Testing Functions - Waeco MAGIC SAFE MS-620 Montage- Und Bedienungsanleitung

Testing functions

8 Testing functions
8.1 Testing the shock sensor
The shock sensor is preset at the plant. Its sensitivity is correctly set if MAGIC SAFE
triggers the alarm in the event of a heavy impact against the vehicle.
Conduct the functional test as follows:
➤
Activate the alarm system (see "Activating MAGIC SAFE" chapter on page 70).
➤
Shake the vehicle.
If the alarm is triggered by blows to the windows, the sensitivity must be
reduced.
Altering the sensitivity
➤
Turn the setting screw of the shock sensor in the – direction to reduce the
sensitivity or ...
Turn the setting screw of the shock sensor in the + direction to increase the
sensitivity.
If the shock sensor is set too sensitively, the alarm may be triggered by passing
vehicles. For this reason set the sensitivity carefully and not too high.
8.2 Testing other alarm inputs
➤
Test the function of the other alarm inputs in sequence by triggering an alarm.
➤
Count the number of flashes on the status LED afterwards.
If the number of flashes does not correspond to the specified value, you need
to check the connections and cables.
Number of flashes
2
3
4
5
8.3 Checking the central locking
If you activate the alarm system (see "Activating MAGIC SAFE" chapter on page 70),
MAGIC SAFE must lock the vehicle if it is equipped with central locking. When you
deactivate the system (see "Deactivating MAGIC SAFE" chapter on page 70),
MAGIC SAFE must unlock the vehicle.
If you have programmed software function 2 ("Locking/unlocking with ignition"),
MAGIC SAFE should lock the central locking approximately 10 s after the ignition is
turned on when the doors are closed. After the ignition is turned off, MAGIC SAFE
opens the central locking again.
68
Alarm cause
Shock sensor
Doors
Bonnet/boot cover
Ignition
MAGIC SAFE