Waeco MAGIC SAFE MS-620 Montage- Und Bedienungsanleitung Seite 55

MAGIC SAFE
➤
Where possible use existing drill holes in the vehicle.
➤
Screw the control device securely to the vehicle with the screws supplied or use
double-sided adhesive tape.
6.3 Installing the status LED
➤
Drill a hole with a diameter of 8 mm in the dashboard or in a plastic cover already
installed in the vehicle.
➤
Guide the status LED cable through the drill hole and insert the status LED in
the drill hole until it latches into place.
✓
The status LED is secured against slipping out with a small hook.
➤
Lay the cable to the control device and insert the plug in the two-pin P3 connec-
tion (see Fig. 6, page 6).
6.4 Installing the alarm siren
The alarm siren can be mounted in the engine compartment.
When mounting it, ensure that the installation location is
– Not in an area exposed to splashing water
– Not near the exhaust system
– Cannot be accessed from underneath the vehicle, to ensure that it
cannot be sabotaged.
➤
Mount the alarm siren with the acoustic horn facing downwards.
➤
Connect the black cable (negative wire) of the alarm siren to the negative termi-
nal of the battery.
➤
Connect the red cable (positive terminal) of the alarm siren to the brown cable
of the P1 main cable tree.
6.5 Installing the shock sensor
➤
Select a suitable installation location on the hinge pillar.
➤
Screw the control device securely to the vehicle with the screws supplied or use
double-sided adhesive tape.
6.6 Installing the bonnet contact switch
This switch need only be installed if the vehicle does not already have one.
➤
Find a suitable location in the engine compartment and drill a hole with a diam-
eter of 8 mm.
➤
During installation ensure that the distance to the closed bonnet is a minimum
of 22 mm and a maximum of 27 mm.
Use putty to check this distance.
You can further reduce the minimum distance by shortening the switch.
➤
Test the switch function after installation.
Installing MAGIC SAFE
55