Waeco MAGIC SAFE MS-620 Montage- Und Bedienungsanleitung Seite 70

Using MAGIC SAFE
9.2 Activating MAGIC SAFE
To activate the alarm system manually, proceed as follows:
➤
Switch the ignition off.
➤
Get out of the vehicle.
➤
Ensure that all doors and covers are closed.
➤
Press button 1 on the remote control.
✓
The alarm siren sounds a confirmation signal, if this function has been set to ON.
✓
The hazard lights flash once.
✓
The status LED starts flashing.
✓
If the alarm system is connected to the central locking, all doors and covers are
locked.
Silent activation and deactivation of the alarm system
You can switch the alarm so that the alarm siren does not sound any confirmation
signal when the alarm is activated.
Proceed as follows:
➤
Switch the ignition off.
➤
Get out of the vehicle.
➤
Ensure that all doors and covers are closed.
➤
Press both buttons on the remote control simultaneously to activate the
alarm.
✓
The hazard lights flash once.
✓
The status LED starts flashing.
✓
If the alarm system is connected to the central locking, all doors and covers are
locked.
Activating the alarm system so that the vehicle can remain occupied
You can set the alarm system so that the shock sensor does not trigger an alarm,
e. g. to leave a pet in the vehicle.
Proceed as follows:
➤
Press button 1 on the remote control.
✓
The alarm siren sounds a signal, if this function has been set to ON.
✓
The hazard lights flash once.
➤
Press button 2 on the remote control within 3 seconds of pressing button 1.
✓
The alarm siren sounds a signal, if this function has been set to ON.
✓
The hazard lights flash once.
9.3 Deactivating MAGIC SAFE
To deactivate the alarm system manually, proceed as follows:
➤
Press button 1 on the remote control.
✓
The alarm siren sounds two confirmation signals, if this function has been set to
ON.
✓
The hazard lights flash twice.
70
MAGIC SAFE