Troubleshooting; Specifications; Declaration Of Conformity (Doc) - Reely Waco Bedienungsanleitung



18. Troubleshooting

Even though the model and the remote control system are state-of-the-art products, there can still be malfunctions or errors. For this reason, we would like to
give you some information on how to deal with possible problems.
Problem
The transmitter does not respond.
The transmitter goes off straight away or after a
short while.
The range of the system is very short.
The model doesn't respond
The motor does not start.


19. Specifications

Transmitter
Frequency range ........................................ 2.4 GHz
Modulation ................................................. FHSS
Number of channels ................................... 4
Power supply ............................................. 8 mignon batteries/rechargeable batteries, 9.6 - 12 V/DC
Model plane
Wing span .................................................. 980 mm
Length of fuselage ..................................... 810 mm
Take-off weight ........................................... Approx. 560 g
Power supply: LiPo rechargeable battery .. 11.1 V (3 cells), 1500 mAh


20. Declaration of Conformity (DOC)

The manufacturer hereby declares that this product adheres to the fundamental requirements and the other relevant regulations of Directive 1999/5/EC.
The declaration of conformity for this product can be found at www.conrad.com.
Remedy
• Check batteries in the transmitter.
• Check polarity of the batteries.
• Check the function switch.
• Bind transmitter and receiver again.
• Check or replace batteries in the transmitter.
• Check batteries in the transmitter and the model.
• Check receiver aerial for damage and electrical continuity.
• Check flight battery or connector in the model.
• Check connections on the receiver.
• Bind transmitter and receiver again.
• Move the motor speed control stick and the corresponding trim slider to the lowest position (motor-
off position). When you reconnect the flight battery to the speed controller and then push the
control stick towards maximum motor speed, the motor should start running.
• Check the flight battery.
• Check motor and speed controller.
49