Safety Cut-Off; Timer - Silvercrest SDI 3500 A1 Bedienungsanleitung

GB
Safety cut-off

Timer

12
NOTE
► If no button is depressed for a period of two hours, the appliance will switch
off even if one or both of the hobs
to wish to cook a dish for more than two hours, or to keep food warm
for more than two hours, adjust the desired time using the timer (see the
"Timer" section). In this way, times of up to three hours can be set.
■ For safety reasons, the pan detection switches the appliance off automatically
(into standby mode) if you remove the cooking vessel from the hob
or fail to place a cooking vessel on it.
■ If you remove the cooking vessel from the hob
The appliance will then switch off. If you place the cooking vessel back on
the hob / before the 20 beeps have finished, the previously defined
settings will be retained.
NOTE
► As soon as you remove the cooking vessel from the hob
shown on the display. After approx. one minute, the "E0" disappears and
the appliance switches itself off. If the hob is still at a temperature in excess
of 50°C, "-H-" will show on the respective display until the temperature
drops below 50°C.
You can preselect a time period from 5–180 mins., after which the respective
hob / will switch off.
1) Begin the cooking procedure (in power or temperature mode) as explained
above.
2) Press the "TIME" button
Set the desired time.
If you briefly press the "+"
or decreases by 5 minutes each time the button is depressed. If you press
and hold down the "+"
decreases by 10 minutes for each time the button is depressed.
The display / now alternately shows the set power level/temperature and
the time that remains until switch-off.
After this time, the respective hob
/ is/are in operation. If you wish
/ , there will be 20 beeps.
/ . "0" appears on the display
/ or "-" / buttons, the time increases
/ or "-" / button, the time increases or
/ switches off automatically.
/
/ , "E0" is
/ .
SDI 3500 A1