Silvercrest SDI 3500 A1 Bedienungsanleitung Seite 14

TIPS
You may select between cooking with power levels or cooking with tempera-
ture settings:
► When you are cooking in the temperature mode, the appliance heats the
cooking vessel to the set temperature. If the temperature falls below the
set temperature, the appliance heats up again. The temperature is thus
maintained at the desired level.
► By adjusting the "power level", the cooking vessel is heated at varying
speeds. The higher the selected power level, the faster the cookware is
heated.
Always use the buttons on the appropriate control panel
hob
3) Press the POWER button
display
light above the POWER button
NOTE
► If you wish to cook in temperature level mode, press the TEMP button
instead of the POWER button
will then appear on the display
4) Press the buttons "+"
desired wattage/temperature appears on the display
5) In order to switch off the hob
button
off at the same time, press the "ON/OFF" button
NOTE
► If both hobs
press the "ON/OFF" button
NOTE
► After switching off in standby mode, the appliance's fans continue to run for
a while to discharge the heat. As long as the hobs
ture in excess of 50°C, the respective display
As long as „-H-" is shown on the display
SDI 3500 A1
/ . You may use the two hobs
/ (right hob
/
/ until the hob
/ are switched off after use or adjustment, you must first
/ by pressing the POWER
/ independently of one another.
/ . The preset wattage can be seen on the
1000 W/left hob 1200 W). The indicator
/ comes on.
/ . The preset temperature of 240°C
/ .
or "-" / as often as is required until the
/ , press and hold down the "POWER"
/ switches off. To turn both hobs
to be able to re-adjust the settings.
/
/ , you can reactivate the hobs
/ or TEMP /
/ for the respective
/
/ .
/
.
/ are at a tempera-
will show "-H-".
buttons.
GB
11