Preparation For Use - Ottobock 21A47 Gebrauchsanweisung

6 Preparation for use

6.1 Preparation
1) Lay the product flat on the table.
1
2
6.2 Application
Complete the following steps to put on the product:
3
2) Thread the loose end of the strap through
the eyelet of the shoulder loop from above.
INFORMATION: Make sure the strap is
not twisted.
3) Lay the loose end of the strap onto the
back of the sleeve.
4) Secure the loose end to the sleeve with
pins.
INFORMATION: The strap should over­
lap the sleeve by about 7 cm.
1) Open the hook-and-loop closure on the
sleeve.
2) Hold the prosthesis between your legs (the
fingers of the prosthesis face up).
3) Pull the sleeve of the product over the
prosthesis.
15