Measuring Functions - Berner BLM 80 Bedienungsanleitung

"Basic Settings"
To access the "Basic settings" menu, press and
hold the basic settings button 4.
Briefly press the basic settings button 4 to select
the individual menu items.
Press the minus button 5 or the plus button 11 to
select the setting within the menu items.
To exit the "Basic settings" menu, press the meas-
urement button 2.
Basic Settings
Tone Signals
Display Illumination
Digital vial
Display rotation
Permanent laser beam
Unit of measure, dis-
tance (depending on
country version)
Unit of measure, angle
With exception of the "Permanent laser beam" set-
ting, all basic settings are retained when switching
off.
Continuous Laser Beam
 Do not point the laser beam at persons or ani-
mals and do not look into the laser beam your-
self, not even from a large distance.
In this setting, the laser beam also remains
switched on between measurements; for measur-
ing, it is only required to press the measuring but-
ton 2 once.
2 609 141 098 • 19.7.13

Measuring Functions

Simple Length Measurement
For length measurements, press button 12 until the
"length measurement" indication appears on the
display.
For several subsequent length measurements, the
On
last measured results are displayed in the meas-
ured-value lines a.
Off
Area Measurement
For area/surface measurements, press button 12
until the indicator for area measurement
On
pears on the display.
Afterwards, measure the length and the width, one
Off
after another, in the same manner as a length
measurement. The laser beam remains switched
on between both measurements.
Auto on/off
On
Off
On
Volume Measurement
For volume measurements, press button 12 until
the indicator for volume measurement
on the display.
Off
Afterwards, measure the length, width and the
height, one after another, in the same manner as
for a length measurement. The laser beam remains
On
switched on between all three measurements.
Off
m, ft, inch, ...
Values above 999999 m
° , %, mm/m
"ERROR" appears on the display. Divide the vol-
ume to be measured into individual measurements;
their values can then be calculated separately and
then summarized.
Continuous Measurement (Tracking) / Mini-
mum/Maximum Measurement (see figure B)
For continuous measurements, the measuring tool
can be moved relative to the target, whereby the
measuring value is updated approx. every
0.5 seconds. In this manner, as an example, you
can move a certain distance away from a wall, while
the actual distance can always be read.
To switch the laser on and for
measuring, briefly press the meas-
uring button 2 once each time.
The measured value is displayed in
the result line c.
Upon completion of the second
measurement, the surface is auto-
matically calculated and displayed
in the result line c. The individual
measured values are displayed in
the measured-value lines a.
Upon completion of the third
measurement, the volume is auto-
matically calculated and displayed
in the result line c. The individual
measured values are displayed in
the measured-value lines a.
3
cannot be indicated;
ap-
appears
English | 21