Herunterladen Inhalt Inhalt Diese Seite drucken

Topping Up The Water; Thermal Cut-Out; Ending Operation; Hints On Cooking With The Steamer - Silvercrest SDG 800 B2 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für SDG 800 B2:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

RP102978 Dampfgarer LB6so Seite 9 Dienstag, 9. September 2014 11:07 11
– If the food being cooked is ready, turn
time selector 14 to "0" to switch off
the appliance.
– If the food being cooked is not yet
ready, put the lid 3 back on and allow
the appliance to continue working.
– If the set time has elapsed before the
food being cooked is ready, set time
selector 14 to the new time required
to continue the cooking process. To be
on the safe side, check the water level
on water level indicator 13.

6.3 Topping up the water

If the water level on water level indicator 13
drops below the MIN marking during
operation, you must top up the water so that
the appliance does not run dry and
overheat.
1. Put clean drinking water in a suitable
pouring vessel.
2. Pour the water through the filling
opening in handles 9 in bottom part 12.

6.4 Ending operation

1. Once the set cooking time has elapsed,
an alarm sounds and the appliance
switches off.
Steaming is one of the healthiest ways of
cooking food. Not only are the nutrients and
colour of foods largely retained, the natural
flavour and bite of food cooked this way
make it a pleasure to eat. This means that
salt, fat and seasoning can be used
sparingly. Steaming is thus especially
recommended for the preparation of baby
food.
SDG 800 B2

7. Hints on cooking with the steamer

2. If you want to switch off the appliance
before the set cooking time has elapsed,
turn time selector 14 to "0".
3. Wait briefly until the steam in the
appliance has dissipated.
4. Remove steamer baskets 5 with the
cooked food.
Warning! The condensate in
collector 7 is hot. Allow it to cool
down
before
collector 7, so that you do not
accidentally scald yourself.
5. Clean the appliance carefully after use
(see "10. Cleaning and storing" on
page 16).

6.5 Thermal cut-out

The
appliance
is
protected
overheating. As soon as all the water in
bottom part 12 has gone, making the
temperature
too high,
switches off automatically.
In this case, disconnect the appliance from
the power supply and allow it to cool down.
You can then run the appliance again with
water in it.

7.1 Using steamer baskets

Depending on requirements, 1, 2 or all 3
steamer baskets 5 can be used.
The steamer baskets 5 are different sizes
and numbered. The relevant number is on
the handle of the steamer basket.
For cooking, always put basket 1 on first,
number 2 on top of it and finally number 3.
you
take
out
against
the
appliance
9

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis