Comfee MPS1-07CRN1 Gebrauchsanweisung Seite 58

Operation
Power switch on/off.
GB
18. [TIMER] button
Used to initiate the [AUTO ON] start time and [AUTO OFF] stop time program, in conjunction with
the ▴ and ▾ buttons.
19. [FAN] button
Press to select the fan speed in two steps – [LOW] and [HIGH]. The fan speed indicator light illu-
minates under different fan settings.
20. LED Display
Shows the set temperature in [°C] or [F] and the Auto-timer settings. While on [DRY] and [FAN]
modes, it shows the room temperature.
Error codes
E1 Room temperature sensor error – Unplug the unit and plug it back in. If error repeats, call for
service.
E2 Evaporator temperature sensor error – Unplug the unit and plug it back in. If error repeats, call
for service.
E4 Display panel communication error – Unplug the unit and plug it back in. If error repeats, call
for service.
Protection codes
P1 Bottom tray is full – Connect the drain hose and drain the collected water away. If error repeats,
call for service.
Note:
When more than one code occurs, the priority of the code display order is:
E4--E2--E1--P1.
Operating instructions
[COOL] operation
– Press the [MODE] button (14) until the [COOL] indicator light comes on.
– Press the [ADJUST] buttons (16) (▴) or (▾) to select your desired room temperature. The temper-
ature can be set within a range of 17 °C – 30 °C.
– Press the [FAN] button (19) to choose the fan speed.
[HEAT] operation (cooling only models without)
– Press the [MODE] button (14) until the [HEAT] indicator light comes on.
– Press the [ADJUST] buttons (16) (▴) and (▾) to select your desired room temperature. The tem-
perature can be set within a range of 17 °C – 30° C.
– Press the [FAN] button (19) to choose the fan speed. For some models, the fan speed can not be
adjusted under [HEAT] mode.
[DRY] operation
– Press the [MODE] button (14) until the [DRY] indicator light comes on.
– Under this mode, you cannot select a fan speed or adjust the temperature.
– Keep windows and doors closed for the best dehumidifying effect.
– Do not put the duct to window.
58