Your Unit At A Glance; Assembly - Comfee MPS1-07CRN1 Gebrauchsanweisung

Note:
Optional parts (*), some models without. All the illustrations in this manual are for expla-
nation purpose only. Your air conditioner may be slightly different. The actual shape shall
prevail.
Note:
If any one of the parts is missing or damaged, contact the retailer.
A. Exhaust hose (supplied), adapter B (round mouth or flat month: depending on models) and
Window Slider Kit and bolt
B. Adaptor B (round mouth)
C. Wall Exhaust Adaptor A
D. Expansion Plug and wooden screw
E. Foam seal
F. Remote Controller and Battery (For remote control models only)
G. Drain hose

Your unit at a glance

▸ Scope of delivery – p. 2
1. Operation Panel
2. Horizontal louver control lever (adjust man-
ually)
3. Carrying Handle (both sides)
4. Remote signal receptor
5. Panel
6. Upper air filter (Behind the grille)

Assembly

▸ Assembly – p. 4
Location
• The air conditioner should be placed on a firm foundation to minimize noise and vibration. For
safe and secure positioning, place the unit on a smooth, level floor strong enough to support
the unit.
• The unit has casters to aid placement, but it should only be rolled on smooth, flat surfaces. Use
caution when rolling on carpet surfaces. Do not attempt to roll the unit over objects.
• The unit must be placed within reach of a properly rated grounded socket.
• Never place any obstacles around the air inlet or outlet of the unit.
• Allow at least 30 cm of space from the wall for efficient air-conditioning.
• Ensure that the window feed-through gives a free throughway to the exterior. Close the window
or door as much as possible.▸ P. 4, item 1
Your unit at a glance
7. Air outlet
8. Wheel
9. Air intake
10. Drain outlet
11. Air intake
12. Lower air filter (Behind the grille)
13. Bottom tray drain outlet
GB
55