Comfee MPS1-07CRN1 Gebrauchsanweisung Seite 56

Assembly
Window slider kit Installation
GB
▸ P. 5, item 2 – ▸ P. 6, item 4
Note:
Window slider kit: minimum = 67.5 cm, maximum = 123 cm
Your window slider kit has been designed to fit most standard Vertical and horizontal window appli-
cations, however, it may be necessary for you to improvise/modify some aspects of the installation
procedures for certain types of window. Window slider kit can be fixed with a bolt (21).
If the window opening is less than the mentioned minimum length of the window slider kit, cut that
one with a hole in it short to fit for the window opening. Do never cut out the hole in window slider
kit.
Installation in a double-hung sash window
▸ P. 6, item 5 –▸ P. 7, item 8
– Cut the foam seal (adhesive type) (E) to the proper length and attach it to the window stool (22).
– Attach the window slider kit to the window stool (22). Adjust the length of the window slider kit
according to the width of window, shorten the adjustable window kit if the width of window is
less than 67.5 cm. Open the window sash and place the window slider kit on the window
stool (22).
– Cut the foam seal (adhesive type) (E) to the proper length and attach it on the top of the win-
dow.
– Close the window sash securely against the window.
– Cut the foam seal to an appropriate length and seal the open gap between the top window sash
and outer window sash.
Exhaust hose installation
▸ P. 7, item 9
The exhaust hose and adaptor must be installed or removed in accordance with the usage mode.
[COOL], [HEAT] (heat pump type) or [AUTO] mode
[FAN], [DEHUMIDIFY] or [HEAT] (electrical heat type)
– Install the window Exhaust adaptor B onto the exhaust hose. Refer to the previous pages for
window kit installation.
– Push the Exhaust hose into the air outlet opening along the the arrow direction.
The exhaust hose can be installed into the wall
▸ P. 8, item 10
NOTICE!
Risk of injury!
Cover the hole using the adaptor cap when not in use.
Do not over bend the duct.
Note:
Not applicable to the units without adaptor A, expansion plugs and wooden screws of
accessories
56
Install
Remove