Renkforce AN-8006 Bedienungsanleitung Seite 73

• Button 0 / BAND (20)
With this button you can select the band range of the radio unit. There are 3 FM ranges and 2 MW ranges available:
FM1 > FM2 > FM3 > MW1 > MW2

On each of the 5 band ranges, 6 stations can be stored on the station button 1-6 (4).
• Buttons UP / # (4) and DOWN / * (8)
With these buttons the receiving frequency can be changed to adjust stations in radio operation.
By pressing a button shortly, you activate the auto-scan. The auto-scan only stops at the next station that can be
received well.
To deactivate auto-scan and set the receiver frequency manually, keep the desired button depressed until MANU
SEEK is displayed (3).

After some time, the device returns to automatic search and the display (3) shows SEARCH briefly.
• Button / AMS (21)
If you press this button shortly, the stations stored on the station buttons 1-6 (4) are played for 5 seconds each. To
stop the auto-scan, press the button again.
When you keep the button pressed, all the stations that can be received well are stored on the station buttons 1-6
(4).
After this procedure, the stored stations are played for approx. 5 seconds each, as described above.
73