Technical Information; Error Messages - Visomat Handy Express Gebrauchsanweisung

What you should know about blood pressure
D
One-off and irregular measurements therefore say little about
your actual blood pressure. A reliable assessment is only possible
when measurements are taken regularly. Discuss the measured
values with your doctor.
EN-54

Technical information

1. Error messages

Error Possible cause
Display Err - 1 Measurement error;
measurement could
not be carried out
due to movement or
speaking.
Display Err - 2 Inflation error;
pressure built up too
quickly or too slowly.
Display Err - 3 Excessive cuff pres-
sure. The cuff may
have been inflated
to the maximum by
moving the arm or the
body.
Display 0 Start/Stop button was
0 accidentally pressed
while the batteries
were being replace.
Irregular pulse, possi-
ble cardiac arrhyth-
mia.
Possible atrial flutter
or atrial fibrillation.
The motion control
detected movement
during the measure-
ment.
E
Remedy
- Repeat the measurement
- Do not move your arm
- Do not speak
- Repeat the measurement
- Do not move your arm
- Do not speak
- Check wrist circumference.
Call the Service hotline if
this occurs repeatedly.
- Repeat the measurement
- Do not move your arm
- Do not speak
Switch unit off and then on
again using the Start/Stop
button.
Repeat measurement after
resting for 3-5 minutes.
Listen out for the device's
pulse beep signals. Possible
influences on the measure-
ment results (depending on
the severity of the arrhyth-
mia) must be discussed with
your doctor!
- Repeat the measurement
- Do not move your arm
- Do not speak
EN-55