Cleaning And Maintenance - Ferm PSM1030P Bersetzung Der Originalbetriebsanleitung

TECHNICAL DATA
Mains voltage
Mains frequency
Power input
No-load speed
Sanding surface
Protection class
Weight
2
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with a
standardised test given in EN 60745; it may be used
to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
DESCRIPTION (FIG. A)
Your finishing sander has been designed for
sanding wood, metal, plastics and painted
surfaces.
1. On/off switch
2. Sanding pad
3. Sanding paper clamp
4. Grip
ASSEMBLY
4
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
Mounting and removing the sanding paper
(sanding paper clamps) (fig. C)
4
Mounting
● Open the sanding paper clamps (4).
PSM1030P
● Mount sanding paper (7) with the required
V~ 220 - 240
Hz 50
● Fold the sanding paper (7) at both ends
W 520
min 7.200
-1
● Close the sanding paper clamps (4) one by
mm 114 x 234
IP 20
kg 2,50
Removing
● Open the sanding paper clamps (4).
● Remove the sanding paper (7) from the
USE
Switching on and off (fig. A)
● To switch on the machine, press the on/off
● To switch off the machine, release the on/off
Hints for optimum use
● Clamp the workpiece.
● Firmly hold the machine by the grip.
● Switch on the machine.
● Place the sanding pad with sanding paper on
● Slowly move the machine over the workpiece,
● Do not apply too much pressure on the
● Switch off the machine and wait for the

CLEANING AND MAINTENANCE

4
● Regularly clean the housing with a soft cloth.
● Keep the ventilation slots free from dust and
● Regularly clean the sanding pad to avoid
grain size onto the sanding pad (3).
around the edges of the sanding pad (3).
one. Make sure that the ends of the sanding
paper (7) are clamped.
sanding pad (3).
switch (1).
switch (1).
the workpiece.
firmly pressing the sanding pad against the
workpiece.
machine. Let the machine do the work.
machine to come to a complete standstill
before putting the machine down.
Before cleaning and maintenance,
always switch off the machine and
remove the mains plug from the mains.
dirt. If necessary, use a soft, moist cloth to
remove dust and dirt from the ventilation slots.
inaccuracies during use.