Cleaning And Maintenance - Ferm AGM1042 Originalbetriebsanleitung

● Keep the spindle lock button (3) pressed and
firmly tighten the tension nut (11) using the
spanner (12).
Mounting the auxiliary grip (fig. C)
● Tighten the auxiliary grip (7) into one of the
mounting holes (13).
USE
Switching on and off (fig. A & D)
● To switch on the machine in continuous mode,
slide the on/off switch lock (2) to the right and
slide the on/off switch (1) in the direction of the
grinding disc (fig. D1).
● To switch off the machine, press the lower part
of the on/off switch (1) (fig. D2).
Hints for optimum use
● Clamp the workpiece. Use a clamping device
for small workpieces.
● Draw a line to define the direction in which to
guide the grinding disc.
● Hold the machine with both hands.
● Switch on the machine.
● Wait until the machine has reached full speed.
● Place the grinding disc on the workpiece.
● Slowly move the machine along the pre-drawn
line, firmly pressing the grinding disc against
the workpiece.
● Do not apply too much pressure on the
machine. Let the machine do the work.
● Switch off the machine and wait for the
machine to come to a complete standstill
before putting the machine down.

CLEANING AND MAINtENANCE

4
Before cleaning and maintenance,
always switch off the machine and
remove the mains plug from the mains.
● Regularly clean the housing with a soft cloth.
● Keep the ventilation slots free from dust and
dirt. If necessary, use a soft, moist cloth to
remove dust and dirt from the ventilation slots.
Carbon brush indicator (fig. A)
If the carbon brushes are worn, the carbon brush
indicator (8) will come on. The carbon brushes
must be replaced by the customer service
department of the manufacturer or a similarly
qualified person.
8
Downloaded from www.Manualslib.com manuals search engine
wARRANty
Consult the enclosed warranty terms.
ENVIRONMENt
Disposal
8
The product, the accessories, and the packaging
must be sorted for environmentally friendly
recycling.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.