Specifications - Sony YP-D2551PT Gebrauchsanweisung

Specifications

Printer
Power requirements
220 to 240 V AC, 50/60 Hz
Power consumption
About 1.0 A max. at 25°C, 240 V AC
Operating temperature
5°C to 35°C (41°F to 95°F)
Operating humidity
20 % to 80 % (no condensation allowed)
Storage and transport temperature
–20°C to 60°C (–4°F to 140°F)
Storage and transport humidity
20 % to 90 % (no condensation allowed)
Dimensions
About 370 × 125 × 417 mm (w/h/d)
× 5 ×16
5
(14 ⁄
8
Mass About 9.5 kg (20 lb 15 oz)
Printing system
Sublimation heat transfer printing
Picture Memory
4 Mbytes
Picture element
Maximum 1365 × 1024 dots (310 dpi)
Thermal head
12.2 dot/mm (1024 dots)
Total gradation
256 levels each for yellow, magenta, and
cyan
Digital interface
Parallel data interface - 1 channel
Amphenole 36-pin connector × 1
Printing time
Approximately 45 seconds
(for color printing, excluding the data
transmission time)
Supplied accessories
Paper tray (1)
Paper ejector (1)
AC power cord(1)
Operating Instructions (1)
Optional accessories
16-split Self-adhesive Pre-cut color
printing pack (ATLUS-20 Series)
4-split Self-adhesive Pre-cut color
printing pack (ATLUS-20 Series)
UPA-2001 paper ejector
Interface cable UPZ-2000M
22
Others
3
⁄ inches)
4
Parallel Interface
Control connector
IEEE 1284-B connector (amphenol 36-pin)
Input: Max. 5 V (TTL)
Output: Max. 5 V (TTL)
Data transmission system
8 bit, parallel,
IEEE STD 1284-1994 (Compatible,
Reverse Nibble and ECP modes)
Logic level TTL
Parallel Interface connector pin assignment
Pin No. I/O Signal
Interface mode
Compatible Nibble
1 I nStrobe HostClk
2 I/O Data1 (LSB)
3 I/O Data2
4 I/O Data3
5 I/O Data4
6 I/O Data5
7 I/O Data6
8 I/O Data7
9 I/O Data8 (MSB)
10 O nACK PtrClk
11 O Busy PtrBusy
12 O PError AckDataReq nAckReverse
13 O Select Xflag
14 I nAutoFd HostBusy
15 Not defined
16–17 GND
18 O Peripheral Logic High (pull up to +5 V at 1 kilohm)
19–30 GND
31 I nInit nInit
32 O nFault nDataAvail
33 Not defined
34 Not defined
35 Not defined
36 I nSelectIn IEEE 1284 Active IEEE 1284 Active
YP-D2551PT supports Compatible, Reverse
Nibble, and ECP modes of the two-way parallel
interface standard (IEEE STD 1284-1994).
Design and specifications are subject to change
without notice.
ECP
HostClk
PeriphClk
PeriphAck
Xflag
HostAck
nReverseRequest
nPeriphRequest