Recording Without Overwriting Existing Material; Recording From A Microphone - Sony WALKMAN MZ-R900PC Bedienungsanleitung

Recording without
overwriting existing
material
If you wish to avoid overwriting the
current contents of an MD, do the
following procedure. All new material
will then be recorded from the end of the
current contents.
Jog lever (L)
1
While the recorder is stopped, press
the jog lever (L).
2
Flip the jog lever (L) repeatedly until
"REC-Posi" flashes in the display,
and then press the lever.
3
Flip the jog lever (L) repeatedly until
"From End" flashes in the display,
and then press the lever.
To start recording from the
current point
Select "From Here" in step 3.
Notes
• The setting will remain even after the power is
turned off.
• If you start recording while the recorder is in
play-pause mode, the recording will begin
from the point at which it is paused.
Recording from a
microphone
Connect a stereo microphone to the MIC
(PLUG IN POWER) jack. For more
information on stereo microphones, see
"Optional accessories" (page 68).
Jog lever (L)
REC
to MIC (PLUG IN POWER)
1
Press and slide REC to the right.
For other operations, see "Recording
an MD right away!" (page 16).
To stop recording, press x
To select microphone sensitivity
1 Press the jog lever (L) while the recorder is
stopped.
2 Flip the jog lever (L) repeatedly until "MIC
SENS" appears in the display, and then
press the lever (L).
3 Flip the jog lever (L) repeatedly until
"SENS HIGH" or "SENS LOW" appears
in the display.
When recording a soft or a sound in the
distance, set to "SENS HIGH". When
recording a loud or a sound at close range,
set to "SENS LOW".
4 Press the jog lever (L).
Stereo
microphone
25
-GB