J) Attaching And Fastening The Car Body; K) Controlling The Vehicle - Reely Carbon Fighter Bedienungsanleitung

If the steering works opposed to the movement at the rotation knob at the transmitter (a turn to the left at
the transmitter makes the wheels go to the right), activate the steering reverse function.
The vehicle should drive forwards if you pull the throttle/brake lever at the transmitter towards the handle.
If this is not the case, either reverse the motor's rotational direction (swap two of the three motor cables) or
activate the motor reverse function at the transmitter.

j) Attaching and Fastening the Car Body

Now put the car body on the holders and fasten the vehicle panelling with the holding brackets removed at the start.
Your car is now ready for its first test run.

k) Controlling the Vehicle

The following figures are only to illustrate the functions and do not necessarily correspond to the design of the transmitter
provided.
1. Release throttle/braking lever, vehicle rolls to a halt (or does not move), lever is in neutral position
2. Drive forwards, pull the throttle/brake lever towards the handle
3. Drive forwards and then brake (vehicle slows down; does not roll to a halt slowly); push throttle/brake lever away
from the handle without stopping
4. Drive forwards and then go into reverse (wait approx. 2 seconds between changes and leave the lever in its
neutral position!)
Wait approx. 2 seconds
43