Steam Ironing; Ironing With Steam Blast; Temporarily Setting The Steam Iron Down; Taking The Steam Iron Out Of Service - Silvercrest SDB 2400 A1 Bedienungsanleitung

2) Check the care instructions on the labels in
GB
garments to see if they are suitable for being
IE
ironed, and at which temperature setting.
CY
3) Press the TEMP
temperature level appears on the display 1 (see
chapter "Meaning of the display indicators").
TEMP 2 button to change to a
Use the
higher or lower temperature level.
As soon as the indicator for the material type stops
fl ashing on the display 1 and a beep is heard, the
set temperature has been reached and you can
begin ironing.
NOTE
If you are ironing very dry and creased fabrics,
you can dampen the material using the spray
function. To dampen the material, press the
button for the spray function 3.

Steam ironing

NOTE
The temperature level must be set to at least level
6. Otherwise no steam can be produced.
Set the steam regulator 4 to the desired steam
■
setting. As soon as you hold the steam iron
horizontally, steam will discharge from the sole
of the iron.
If you set the steam regulator 4 to
■
the steam iron vertically no steam will come out
of the sole of the iron.

Ironing with steam blast

The steam blast function is especially suitable for
smoothing diffi cult-to-reach parts of a garment.
1) Slightly raise the steam iron.
2) Press the steam blast button 5 for a blast of
steam.
8
button q until the required
or hold
Temporarily setting the steam iron
down
CAUTION – RISK OF FIRE!
Never leave a hot steam iron unattended if it is
switched on or connected to the mains power
supply.
1) To switch off the steam iron, press and hold the
button q or the
TEMP
until you hear a beep and the display 1 lights
up red and indicates OFF.
Or:
TEMP 2 button repeatedly until
2) Press the
you hear a beep and display 1 lights up red
and indicates OFF.

Taking the steam iron out of service

1) Remove the plug from the mains power socket.
2) Empty the water tank and clean the sole of
the iron.
3) Place the cooled-down steam iron on the
base 7.

Anti-drip system

With conventional steam irons it can happen that
water drips from the iron sole at low temperatures.
This steam iron, however, is equipped with a special
anti-drip system. At low temperatures the steam iron
automatically switches off the steam blast function.
When this happens, a "click" can be be heard.
Set a suitable temperature level. As soon as this is
reached, steam production is resumed.
TEMP 2 button
SDB 2400 A1