Cleaning, Maintenance, And Storage; Transport; Disposal And Recycling - Parkside PWDS 920 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Connections and repairs of electrical equipment may only
be carried out by an electrician.
Please provide the following information in the event of any
enquiries:
• Type of current for the motor
• Machine data - type plate

10. Cleaning, maintenance, and storage

m Important!
Pull out the power plug before doing any cleaning and main-
tenance work on the equipment. Risk of injury from electric
shock!
m Important!
Wait until the equipment has cooled down completely! Risk
of burns!
10.1. Cleaning
• Keep the equipment free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it down
with compressed air at low pressure.
• We recommend that you clean the equipment immediately
after you use it.
• Clean the equipment regularly with a damp cloth and
some soft soap. Do not use cleaning agents or solvents;
these may be aggressive to the plastic parts in the equip-
ment. Ensure that no water can get into the interior of the
equipment.
10.2. Maintenance
Check the power tool and accessory parts (e.g. insertion
tools) for wear and damage before and after each opera-
tion. lf necessary, replace worn out or damaged parts with
new parts and make sure to comply with the operating in-
structions. Observe any technical requirements.
10.2.1. Grinding plate, brushed edge
Have a qualified specialist replace damaged or worn out
grinding plates (1) and brush edges (A) with new ones of the
same type.
10.2.2. Replacing the power supply line
lf the power supply line of this power tool is damaged, it must
be replaced by the manufacturer or the customer service or
an equally qualified person in order to avoid risks.
Warning! There are no parts inside the power tool
which can be serviced by the operator! Never open the
power tool! Take it to a qualified specialist for further
maintenance!
10.4. Storage
m Important! Pull out the mains plug!
1. Whenever you do not use the power tool, you must keep
it in a dry and well ventilated place out of the reach of
children, e.g. on a high cabinet or in a closed place.
2. Keep power tool, instruction manual and accessory
parts, if any, together in the original packaging, if pos-
sible. Thus you have all information and parts available
at any time.

11. Transport

m Important! Pull out the mains plug!
1. Always hold the power tool by its handle.
2. To avoid transport damages, you must pack the power
tool or use the original packaging.
3. Protect the power tool against vibrations and shock, es-
pecially during transport in vehicles.

12. Disposal and recycling

The equipment is supplied in packaging to prevent it from be-
ing damaged in transit. The raw materials in this packaging
can be reused or recycled. The equipment and its accesso-
ries are made of various types of material, such as metal and
plastic. Defective components must be disposed of as special
waste. Ask your dealer or your local council.
The packaging is wholly composed of environment-
ally-friendly materials that can be disposed of at a lo-
cal recycling centre.
Contact your local refuse disposal authority for more
details of how to dispose of your worn out electrical
devices.
Old devices must not be disposed of with household
waste!
This symbol indicates that this product must not be
disposed of together with domestic waste in compli-
ance with the Directive (2012/19/EU) pertaining to
waste electrical and electronic equipment (WEEE). This
product must be disposed of at a designated collection point.
This can occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical and elec-
tronic equipment. Improper handling of waste equipment
may have negative consequences for the environment and
human health due to potentially hazardous substances that
are often contained in electrical and electronic equipment.
By properly disposing of this product, you are also contribut-
ing to the effective use of natural resources. You can obtain
information on collection points for waste equipment from
your municipal administration, public waste disposal author-
ity, an authorised body for the disposal of waste electrical
and electronic equipment or your waste disposal company.
GB 19