Rs-485 Termination; Protocol; Baud Rate Setting - Abus TVCC75200 Bedienungsanleitung

9.2 RS-485 Termination

st
The 1 DIP of SW2 is used for 100Ω termination.
st
Set on 1 DIP of SW2 only by the last connected camera from the loop (CAM n).
Even in case of only one camera, set ON 1

9.3 Protocol

rd TH
The 3 , 4 of DIP SW2 above are used for Protocol Setting.
Factory Default: Pelco-D or Pelco-P (Auto detection)
rd
DIP SW2 - 3 4
OFF / OFF
ON / ON

9.4 Baud Rate Setting

th th
The 7 , 8 SW of DIP SW2 is used for baud rate setting.
With DIP SW2 baud rate can be changed to 4800bps, 9600bps.
Factory Default: 2400bps.
th
DIP SW2-7
OFF
OFF
ON
ON
nd th th
* The 2 , 5 , 6 of DIP SW2 are not used.
th
DIP SW2-8
OFF
ON
OFF
ON
st
-DIP of SW2.
Pelco-D or Pelco-P
Maxpro protocol
th
BAUD RATE
Not Used
2400bps
4800bps
9600bps
81