Instructions For Operation; Before Operation - Max HN120 Betriebsanleitung

2.
WARNING:
Wear safety glasses or goggles danger to the eyes always exists due to the possibility of dust being
blown up by the exhausted air or of a fastener flying up due to the improper handling of the tool. For
these reasons, safety glasses or goggles shall always be worn when operating the tool.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute, ANSI
Z87.1 (Council Directive 89/686/EEC of 21 DEC. 1989) and provide both frontal and side protection.
The employer is responsible to enforce the use of eye protection equipment by the tool operator
and all other personnel in the work area.
Keep hands and body away from the discharge outlet when driving the fasteners because of
WARNING:
dangerous of hitting the hands or body by mistake.
Magazine cap lever
1. Release the magazine lock lever.
Magazine holder
2. Pull out the

4. INSTRUCTIONS FOR OPERATION

Read section titled サSAFETY INSTRUCTIONSサ.
1.

BEFORE OPERATION

q Wear Safety Glasses or Goggles.
w Do not connect the air supply.
e Inspect screw tightness.
r Check operation of the contact arm & trigger if moving smoothly.
t Connect the air supply.
y Check the air-leakage. (The Tool must not have the air-leakage.)
u Hold the Tool with finger-off the trigger, then push the contact arm against the work-piece.
(
tool must not operate.)
i Hold the Tool with contact arm free from work-piece and pull the trigger. (The Tool must not
OPERATION
NAIL LOADING
q Lock the trigger and disconnect the air hose.
w Adjust the magazine direction in tune with the length of pins (or nails) used. First,
push the magazine cap lever to open the magazine cap.
e Check adjustment:
Release the magazine lock lever to detach the magazine from the magazine
h o o k , a n d r e m o v e t h e m a g a z i n e f r o m t h e m a g a z i n e h o l d e r.
T
10
h e