Maintain For Performance; Storing; Troubleshooting/Repairs - Max HN120 Betriebsanleitung

5. MAINTAIN FOR PERFORMANCE

q DO NOT FIRE THE NAILER WHEN IT IS EMPTY
wUSE RECOMMENDED OIL
The velocite or turbine oil should be used to lubricate the tool. Upon completion of operations,
place 2 or 3 drops of oil into the air plug inlet with the jet oiler. (Recommended Oil : ISO VG32)
e INSPECT AND MAINTAIN DAILY OR BEFORE OPERATION
WARNING:
Disconnect air supply and empty the magazine when inspecting or maintaining the tool.
(1) Drain air line filter and compressor
(2) Keep lubricator filled in air 3-pieces set
(3) Clean filter element of air 3-pieces set
(4) Tighten all screws
(5) Keep contact arm moving smoothly

6. STORING

q When not in use for an extended period, apply a thin coat of the lubricant to the steel parts to
a v
rust.
w Do not store the tool in a cold weather environment. Keep the tool in a warm area.
e When not in use, the tool should be stored in a warm and dry place. Keep out of reach of
children.
r All quality tools will eventually require servicing or replacement of parts because of wear from
t
normal use.
7. TROUBLE SHOOTING/REPAIRS
The troubleshooting and/or repairs shall be carried out only by the MAX CO., LTD.authorised
d i s t
or by other specialists.
o
h
r i b u
16
i d
e
t o r s