Max HN120 Betriebsanleitung Seite 13

Attachment A
Regular screwdriver
Contact arm
Nose
Attachment B
REPLACING THE ATTACHMENT
The machine comes with the attachments B and C as accessories. See the following
for the replacement method.
WARNING:
When replacing the attachment, be sure to lock a trigger and remove an air hose.
PROCEDURE
q Remove the attachment A which has been attached at shipment; hold and draw it
out with your hand, while holding it.
※ If it is not smoothly drawn out, insert a regular screwdriver, etc. into the clearance
between a contact arm and it, and squeeze it to remove.
w Put down the attachment B or C, insert the nose of the machine, and push it
against to attach.
HOW TO REMOVE PLASTIC SHEET
As nails are driven the plastic sheet will feed out of the tool. When sufficient strip
has been fed out it can be torn away by pulling against the tear edge in the nose.
13