Max HN120 Betriebsanleitung Seite 11

Magazine hook
Hook mating
part
Magazine
For 22 to 32 mm
Collar
For 38 to 65 mm
Magazine lock lever
Hook mating
Magazine hook
Magazine
Magazine cap
Magazine cap lever
Door
Door lever
Door
Nose
Feed pawl
Bridge
r Determine the magazine direction in tune with the length of pins (or nails) used,
fit the magazine collar into the groove in the magazine holder, set the magazine
hook onto its mating part, and push the magazine lock lever to secure the
magazine.
CAUTION:
● At shipment, the magazine has been set in the direction for the pin/nail length
of 22 to 32 mm. When using 38 mm or longer pins/nails, set the magazine
reversely.
● Be sure to set the magazine direction in tune with the length of pins (or nails)
used. If used in the inadequate direction, the pins (or nails) are not fed
properly.
t Push the magazine cap lever. With the magazine cap opened, set the pins (or
nails) and pull out the front end of the pin (or nail) coil.
y Push the door lever to open the door.
u Push in the pin (or nail) coil along the bridge until it has reached the end. Pushing
it in causes a feed pawl to swing away in between the first and second pins (or
Coil
nails). Stop pushing it there.
CAUTION:
Confirm that the first pin (or nail) has been entirely set before the feed pawl (into
the nose).
11