Replacing A Soldering Tip; Maintenance And Cleaning; Service Centre - Parkside PLP 100 Bedienungs- Und Sicherheitshinweise

Use / Maintenance and cleaning / Service centre
©

Replacing a soldering tip

CAUTION! DANGER OF BURNS! Allow the device to
cool down before replacing a soldering tip.
Release the two union nuts
Pull the soldering tip
Insert another tip into the holder.
Tighten the two union nuts
©

Maintenance and cleaning

WARNING!
on the device always pull the mains plug out of the mains socket and
allow the device to cool.
Clean the device after you have finished using it.
Use a cloth and a little mild detergent for cleaning the device.
In no circumstances use sharp objects, or petrol, solvents or clean-
ing agents that might attack plastic. Do not allow any liquids to
enter the inside of the device.
©

Service centre

½
WARNING!
ified specialist personnel using original manufacturer
parts only. This will ensure that your device remains safe to use.
½
WARNING!
replaced, always have the replacement carried out
by the manufacturer or his service centre. This will ensure
that your device remains safe to use.
14 GB
using the open spanner
2
or out of the holder.
1 7
using the open spanner
2
RISK OF INJURY! Before you carry out any work
Have your device repaired only by qual-
If the plug or mains lead needs to be
.
9
.
9