Button
Function
(9)
Screen mirroring vertical
(10)
Menu navigation up
(11)
Picture brightness increase
(12)
Menu navigation down
Display of the distance lines on/off (if the menu is not active and the distance lines have
been activated in the menu)
(13)
Sets the time until automatic deactivation
0 = Automatic deactivation off
10 - 90 = Time until automatic deactivation in minutes
(14)
Display of the camera number
(15)
Manual selection of the camera inputs (CAM1 > CAM2 > CAM3 > CAM1 > ...)
12. Maintenance and cleaning
Only clean the monitor with a slightly moistened cloth. Never use any solvents. They may damage the
housing surfaces.
Do not apply any strong pressure on the sensitive display surface.
Fuse replacement
If it becomes necessary to replace a fuse, make sure that only fuses of the prescribed type and nominal
current are used (see „Technical data").
Never repair fuses or bridge the fuse holder.
• Disconnect the monitor from the power supply.
• Pull the car flat-plug fuse from the fuse holder in the red connection line.
• Replace the fuse with a fuse of the same type.
• After this, you can reconnect the monitor to the board mains and take it into operation.
• Should the fuse trigger again, have the device repaired in a specialist workshop.
27