Recording; A) Manual Recording With Memory Limit - Conrad 75 28 09 Bedienungsanleitung

9. Recording

The product has several recording modes that you can set manually.
By changing the recording mode, you can defi ne the recording behaviour (manual or surveil-
lance camera) and the relevant memory options.

a) Manual recording with memory limit

In this setting, recording will stop (without manually ending) once the storage capacity is reached
(micro SD card full).
Proceed as follows:
Press the 'POW/REC' key (13) to switch on the
product.
The status LED (10) lights up red. This indicates
that your product is switched on and is in 'stand-
by' mode.
Start recording
Press the 'POW/REC' key (13) again to start
recording.
The status LED (10) starts to fl ash red. This indicates that your product is recording.
The blue status LED (9) should not light up or fl ash.
Terminating recording
Press the 'POW/REC' key (13) again.
The status LED (10) is continuously red. This indicates that your product is back in 'stand-by'
mode.
The status LED (10) lights up red. This indicates that your product is switched on and is in
'stand-by' mode.
9 10
13
35