D) Automatic Recording Without Memory Limit - Conrad 75 28 09 Bedienungsanleitung

d) Automatic recording without memory limit

In this setting, recording starts automatically when the camera detects a contrast difference (e.g.
motion) in the screen. Recording will stop after one minute (without manually ending). Once the
storage capacity is reached (micro SD card full), the oldest data will be overwritten.
Proceed as follows:
Press the 'POW/REC' key (13) to switch on the
product.
The status LED (10) lights up red. This indicates
that your product is switched on and is in 'stand-
by' mode.
Press the 'LOOP/MOTION' key (11) until the
blue status LED (9) fl ashes quickly.
Start recording
Press the 'POW/REC' key (13) again to start recording when a contrast difference occurs.
The status LED (10) starts to fl ash red. This indicates that your product is recording.
The blue status LED (9) should fl ash quickly.
Terminating recording
Press the 'POW/REC' key (13) again.
The status LED (10) is continuously red. This indicates that your product is back in 'stand-by'
mode.
38
9
11
10
13