Assembly; A) Installation On A Bicycle Handle Bar - Conrad 75 28 09 Bedienungsanleitung

7. Assembly

a) Installation on a bicycle handle bar

The connection for this product and the supplied support for bicycle handle bar enables you to
record video and audio data as you cycle.
The product is only to be used in a dry environment. The product must not be-
come damp or wet as this poses the risk of electric shock or product damage!
Proceed as follows:
• Insert the scratch proof rubber (A) into the
bottom half (B) of the support.
• Position the top half (C) of the support on the
top of the handle bar.
• Hook the bottom half into the top half of the
support and push them together.
Make sure that the scratch
proof rubber does not crease.
• Fix the support to the handle bar using the
toggle screw (D).
• Tighten the toggle screw only by hand.
• Using the installation thread (6), screw the
product to the fi xing screw on the support (not
up to the stop).
• Align the product to the viewing angle you
want and fasten using the locking screw (E).
30
C
B
E
A
D