Accessories - Tennant F3 Bedienungsanleitung

Machine operation
S
Press the brush motor switch (2) (to the right or left).
The motor starts.
S
If you raise the bar (7) slightly, the machine moves to
the right (D).
S
If you lower the bar, the machine moves to the left (D).
S
If you keep the bar in its central position, the machine
works on the spot.
After use
S
Squeeze the shaft adjustment handle (5) and shift the
bar (7) into its vertical position.
S
Then tip the machine onto its wheels (9) and press
the brush motor switch (2) briefly. The accessory (11)
disengages.
S
Remove the plug from the power socket and wind the
electric cable around the handle bar (1) and cable
hook (8).
Thorough cleaning the easy way
For thorough cleaning, equip your machine with the following

accessories:

S
Solution tank (13)
S
Scrubbing brush (11) or drive plate with pad.
S
Fasten the tank to the mounting (14).
S
Slide the outlet hose (12) onto the water connector
(16).
S
Fill the tank (13). Then fit the brush or drive plate with
pad.
S
Control the flow of liquid with the tank lever (15) by
pulling the lever (15) upwards.
S
Vacuum the dirty wash solution a section at a time
with a water extractor.
Shampooing thoroughly and efficiently
For shampooing, equip your machine with the following
accessories:
S
Solution tank; 0.3 Perlon shampooing brush or pad for
textile floorcoverings.
S
The working procedure is in principle the same as for
thorough cleaning.
S
Start the machine with the shampooing brush dry.
S
Meter a small amount of liquid until the bristles are
saturated with foam.
S
Run the machine with the rotating brush from right to
left or viceversa.  Immediately after this, run the
machine in the same way
in the reverse direction, but with an overlap of about a
quarter of the strip already treated (E.)
S
Only then run the machine in a spiral pattern over the
shampooed strips.  In doing so, work both strips at
the same time (F.)
S
During shampooing it is highly advisable to
immediately remove the dirt−laden foam a section at a
time with a water extractor.
F3/F3+/F8/F12 9002026 (04−11)
Home
Assembly instructions for spray unit
Routine cleaning
For routine cleaning, equip your machine with the following
accessories:
Polishing with F12/F8 high speed
For polishing, equip your machine with the following
accessories:
Find... Go To..
English
S
Fit the holder for the spray can to the bar (7) with the
holder pointing upwards and, when viewed from the
operating side, to the left (G).
S
Hook the spray can's tongue onto the holder, pivoting
the holder
back until the ball catch engages.
S
Then slide the spring clip over the shaft adjustment
unit (7).
S
Attach the box on the right or left as desired (H).
S
Point the universal−jointed hose in the desired
direction.
S
Spray unit, drive plate for pads, pad for F8/F3 low
speed or Spray unit, drive plate for pads, pad for
F12/F8 high speed
S
Fill the spray can with the desired product.
S
Fit the drive plate with the desired pad.
S
Start the machine.
S
When you pull the Spray unit lever a few times the
cleaning agent is sprayed onto the floor. Now start
cleaning immediately until a shine is produced.
S
We advise cleaning the surface in relatively small
areas at a time. The machine is ideal for cleaning with
polymer dispersions. The coating's resistance to foot
traffic and general wear and tear is preserved.
Streaks and marks are easier to remove.
S
Drive plate for pads, white pad
S
Fit the drive plate with the pad.
S
Then start the machine.
EN
5