Attaching The Exhaust Air Hose - hanseatic SY-103A6-P1-C59-L122-600 Gebrauchsanleitung

Page EN-14 Assembly
(11)
5. Carefully hang the exhaust hood on the
two round-head screws (11) using the key-
hole openings.
6. If necessary, remove the exhaust hood
again to loosen or tighten the screws in
order to ensure that the hood is flush with
the wall.
2x
(12)
7. Turn two round-head screws (12) into the
prepared dowels to secure the exhaust
hood, and screw the exhaust hood tightly
to the wall.
(11)
(15)
8. Place the grease filter (15) with the pins
into the openings.
9. Push the locks (14) up; snap the grease
filters (15) in and release the locks.
10. Close the cover (13) back down again
and allow it to click into place. The ex-
haust hood is now mounted to the wall.

Attaching the exhaust air hose

The exhaust air hose (4) must be installed if
you intend to use the exhaust hood with ex-
haust air operation.
(12)
(4)
1. Insert the end of the exhaust air hose (4)
with the larger diameter (153 mm) into the
connection with the check valve.
2. Secure the lower end of the exhaust hose
with the cable tie (9).
(14) (13)
(9)