9. Maintenance
Regularly check the technical safety of the effect beamer, e.g. for damage to the mains cable or the casing.
If you have reason to believe that the device can no longer be operated safely, disconnect it immediately and make
sure it is not unintentionally operated. Pull the mains plug from the mains socket!
It can be assumed that safe operation is no longer possible if:
• the device is visibly damaged
• the device no longer works
• the device was stored under unfavourable conditions for an extended period of time or
• after exposure to extraordinary stress caused by transport
Before cleaning the effect beamer, observe the following safety instructions:
Disconnect the device from all voltage sources before cleaning.
The device contains no parts that require servicing by the user. Therefore, never open the
device.
Only qualified experts familiar with the hazards involved and the relevant regulations must
perform repairs.
The outside of the effect light should only be cleaned with a soft, dry cloth or brush.
Never use any aggressive cleaning agents or chemical solutions as these may damage the surface of the casing.
10. Disposal
Dispose of the product according to the applicable statutory provisions at the end of its service life.
11. Technical Data
Operating voltage ............................................... 90 - 250V / 50/60 Hz
Power consumption ............................................ 45 W max.
Operating modes ................................................ DMX / standalone / master-Slave
LEDs .................................................................... 39 x 1 W high performance LED (9 red, 18 green, 12 blue)
DMX protocol ...................................................... DMX 512
DMX channels ..................................................... 4
Dimensions ......................................................... 186 x 252 mm
Weight ................................................................. 2.2 kg
33