Slave Mode - MC Crypt LumiPAR 39-1 Bedienungsanleitung

7. Commissioning

Slave mode

• Press the button MODE (1) until the display (4) shows "SLA". "SLA" means that the device is in slave mode.
• In this operating mode, the light effect covers 3 DMX channels for the respective intensity of the colours red, green
and blue. The DMX starting address is set to the DMX channel 1 and the device receives the DMX data from a
connected master device in automatic, sound-to-light or fixed-colour-setting mode.
• Once a DMX signal is received from the master device, an LED flashes at the right side below the "S" in the
display (4).
DMX mode
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the controller.
This DMX starting address specifies the first DMX channel to which the effect light responds. The remaining control
channels come after this first DMX channel (DMX starting address).
The effect light requires 4 free DMX channels.
Setting the DMX starting address
• Press the button MODE (1) until the display (4) shows "d". "d" means that the device is in DMX mode.
• Briefly after this, the display (4) shows the DMX starting address.
• Set the desired starting address with the buttons UP (2) or DOWN (3). The starting address is assumed after
approx. 3 seconds and displayed alternatingly with the "d".
• Once a DMX signal is received from the connected DMX controller, and LED flashes at the right side below the
"d" in the display (4).
• In this operating mode, the effect light covers 4 DMX channels. Their functions are listed below.
• The DMX signals from the controller are output unchanged at the DMX OUT (6) port, so that subsequent light
effects are controlled synchronously.
31