Handling - MC Crypt LumiPAR 39-1 Bedienungsanleitung

7. Commissioning
DMX channel functions:
DMX channel DMX values
CH1 000-255
CH2 000-255
CH3 000-255
CH4 000-127
128-227
228-255
Display deactivation
• The display (4) switches off automatically after 25 seconds without any button being pressed.
• Press any button to activate the display (4) again. This button does not trigger any function yet. Only the next
button pressed when the display (4) is lit will be accepted.
Key lock
• Press the button MODE (1) for more than 3 seconds to activate the key lock.
• The display (4) shows "LOC", alternating with the operating mode set.
• Press the button MODE (1) again for more than 3 seconds to deactivate the key lock again.

8. Handling

• Never connect the mains plug to a mains socket immediately after the device was taken from a cold to a warm
environment. The resulting condensation may destroy the device. Allow the device to reach room temperature
before connecting it. Wait until the condensation has evaporated.
• Never pull the mains plug from the mains socket by the cable. Only pull it from the mains socket by the intended
grip areas.
• Disconnect the mains plug from the mains socket in thunderstorms for reasons of safety.
• Never put any filter foils, masks or other materials over the light exit. This may cause heat damage and danger
of fire.
• The device may heat up strongly during operation. Never touch the casing during operation. Let the effect light
cool off for 20 minutes after operation before touching or cleaning the casing.
32
Function
Brightness red
Brightness green
Brightness blue
Overall brightness
Flashing effect, slow > fast
Full brightness, no flashing