Maintenance; Operation - MC Crypt GST-102 Star Bedienungsanleitung

• Install the laser effect device using a mounting bracket on the ceiling, the wall or on a suitable
crossbeam. When installing it, make sure that the device cannot swing freely.
• Secure the device with fastenings that are compatible with the fastening surface and suitable
for carrying the weight of the light effect device.
• Secure the installation with an additional suitable safety restraint cable or net. The safety
restraint cable or net must be able to support the light effect device in the event of a fault in the
main support system.
• Set the desired angle of inclination and tighten the two bracket locking screws well.
Controls and Parts
(1) Laser outlet - Attention, here the laser beam is released
(2) Laser outlet, green - Attention, here the laser beam is released
(3) Connection jack for power supply unit
(4) Effect selector switch
(5) ON/OFF switch
Connecting the Power Adaptor
The mains socket, to which the laser is connected, must be easily accessible
so the device can be quickly disconnected from the mains supply in the case
of a fault.
Do not let the mains cable come into contact with other cables.
Be careful when handling the mains cables and main connectors. Mains volt-
age can give severe electric shocks, which can be fatal.
Do not leave the cables trailing free; route them in an orderly and profes-
sional way to prevent accidents.
• Plug the low voltage plug of the power supply unit enclosed into the connection jack for the
power supply unit (3) on the rear of the device.
• Plug the power supply unit into a wall socket.

Operation

• The on/off switch (5) is used to switch the laser on and off.
Switch depressed: Laser is switched on
Switch not depressed: Laser is switched off
• If the effect selector switch you can control the laser effect.
Handling
• Never switch the laser effect device on and off at short intervals. This will considerably reduce
the working life of the device.
• The device is not suitable for continuous use. Pauses in operation increase the working life of
the product.
• Never switch on the device immediately after it has been taken from a cold into a warm envi-
ronment. The condensation that forms might damage your unit.
Allow the device to reach room temperature before switching it on. Wait until the condensation
has evaporated.
• To ensure suffi cient ventilation, do not cover the device. In addition, the air circulation must not
be obstructed by objects such as magazines, tablecloths, curtains or similar.

Maintenance

Before cleaning the laser, disconnect it from the power supply (disconnect
the power supply unit).
Make sure that the inside of the device does not get wet or damp.
The outside of the device should be cleaned with a soft, slightly damp cloth or dry brush.
Never use aggressive cleaning agents or chemical solutions as these may damage the surface
of the housing.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the house-
hold waste!
Dispose of the device in accordance with the valid statutory regulations once it has
become unusable.
Technical Data
Operating voltage (Adaptor)
Operating voltage (Laser)
Power consumption
Laser output
Wavelength
Laser class
Dimensions (without mounting bracket)
This product complies with the national and European legal requirements.
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfi lming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.
© Copyright 2011 by Conrad Electronic SE.
100-240 V/ 50/60 Hz
5 V DC
0.1 / 3.5 W Standby/max.
<1 mW
532 / 650 nm
2
84 x 70 x 32 mm