Master-Slave Mode; D) Automatic Operation; Automatic Mode; E) Sound-To-Light Mode - MC Crypt DL-1114S Bedienungsanleitung

10. Operation
c) Master-Slave Mode
• Push the button FUNC until SLNd is displayed and push the button ENTER.
• Select the NASt with the arrow buttons to define the effect light as master device (control via the integrated control-
ler).
• Select the menu SLAv with the arrow buttons to define the light effect as a slave device (control via the controller of
the connected master device).
• Confirm your selection again with ENTER.
If the device is to be operated as a single device (stand alone), it must be defined as a master device.
Only one device in a master-slave-chain must be defined as master device. All other devices must be
defined as slave devices.
In inverted slave mode, the device behaves opposite to the master device.
d) Automatic Mode
• Push the button FUNC until ShNd is displayed and push the button ENTER.
• Select the desired automatic effect SH 0 to SH 8 with the arrows.
• Confirm your selection again with ENTER.

e) Sound-to-Light Mode

• Push the button FUNC until SoUn is displayed and push the button ENTER.
• Select on with the arrows to activate sound-to-light mode.
• Confirm your selection again with ENTER.
• The effect light is controlled via an installed microphone in time with the music.
• Set the music control sensitivity with the SOUND SENSITIVITY controller at the device.
27