Memory Recall - Beurer BM 20 Gebrauchsanleitung

9. Memory recall

You can recall stored results from the two user memories and display averages.
• Press memory buttons M1 or M2. First the average is displayed of all the results
held in this user memory. This is indicated by reading 'A'.
• Continue pressing the memory button to recall other individual measurement
results - the first result to appear is that of the most recent value measured.
These individual values are indicated by memory location numbers 1 to 30. After
approx. 4 seconds, the date of the respective measurement result is displayed
and then the time after a further 4 seconds.
• Once 30 individual values are in the memory, the oldest value is deleted in order
to make room for the new measured value.
• Switch off the device using the Start/Stop button or else the device will switch
off automatically after approx. 30 seconds.
Note: You can also use the two user memories to save measurement results
separately, e.g. in the morning and evening.
Deleting saved values
You can delete saved values individually or else you can delete all of them.
• To delete individual values, first select the stored value you wish to delete and
keep memory button M1 or M2 depressed. The display starts blinking. Keep
holding the button depressed until the display has completely cleared.
• To delete an entire user memory, you have to select the appropriate user memory.
The average is displayed and indicated with 'A'. Hold the memory button M1 or
M2 depressed until the display starts blinking and keep the button depressed
until the display completely clears.
10. Cleaning
• Clean your blood pressure computer carefully only with a slightly moistened
cloth.
• Do not use detergents or solvents.
• On no account must you immerse the computer in water, otherwise liquid can
enter it and cause demage.
• When storing the device, make sure that no heavy objects are placed on top of
it. Remove the batteries. The cuff tube should not have any sharp kinks
11. Error recovery
Error messages may appear if
• you move or talk during measurement
• the cuff tube is not inserted properly
• the ON/OFF button is pressed when inserting the batteries
• the cuff is inflated for longer than 20 seconds
• blood pressure is unusually high or low
• inflation pressure is higher than 300 mmHg
17