C) Programming Via The Transmitter - Reely Rex-X Bedienungsanleitung

6. „Reverse Type" (Driving Mode)
This setting determines the driving mode.
„Proportional Rev.Lock out": Before switching between forwards and reverse driving, the throttle/brake lever at the
transmitter must be put in neutral position briefly (approx. 2 seconds). This avoids gear damage due to too-fast chan-
ging between forward and reverse driving.
If you shift directly from forwards to reverse, the speed controller's brake will be activated (the vehicle will not go
backwards!).
„Proportional w/o Reverse": Reverse driving is deactivated.
„FWD to Brake and Reverse": You can only switch from forward to reverse driving if the motor has stopped.
7. „Motor Type"
This setting must be left set to „Brushless w/o Sensor" since the motor of the car model is a sensor-free brushless
motor. The setting „sensor only" must not be used for this.
8. „Motor Timing"
This setting influences motor running characteristics (similar to early ignition of a combustion engine).
Setting „lowest" means that the motor has a little more torque as compared to the basic settings („low"), and a slightly
lower maximum speed. The setting „highest" means that the motor has a slightly higher maximum speed and a little
less torque. In both cases, the current values change however. Additionally observe the temperatures of the motor
and speed controller in operation.

c) Programming via the Transmitter

The speed controller cannot only be programed via the enclosed programming card, but also via the throttle/brake
lever of the transmitter. For this, the programming mode of the speed controller must be activated first, of course.
Proceed as follows:
• Turn off the speed controller (switch to „OFF"; see figure in chapter 9. f).
• Now connect the two fully charged 2-cell LiPo driving batteries to the speed controller via the enclosed Y-recharge-
able battery adapter.
• Move the throttle/brake lever into full throttle for forward driving (pull the throttle all the way towards the handle) and
keep it there.
• Switch on the speed controller with the on/off switch (switch position „ON"); keep the throttle/brake lever in the
throttle position for forward driving. Do not release!
The LED now flashes green and the motor emits sound signals (they are generated by the brief activation of the
motor by the speed controller).
The speed controller first starts the programing mode for the full throttle positions for forward and reverse driving
and the neutral position. Keep the throttle/brake lever in the full throttle for forwards driving, do not release, do not
move!
The motor emits a long beep (approx. 1 second).
Then the LED flashes red and the motor emits brief sound signals.
After a few more seconds, the motor emits another long beep.
Then the LED flashes yellow and the motor emits brief sound signals.
52