Utilisation; A) Switching On; B) Inserting A Cd - Renkforce CDM-900MUSB Bedienungsanleitung

10. Operation
Only take the device in operation once you have become familiar with its features and these
operating instructions. Check again that all connections are correct. Do not put the product into
operation if it is damaged.
The amplifier for this equipment should always be the last to be turned on and the first to be
turned off. This will prevent any undesired noises (which can typically occur when switching
off the player) from damaging the amplifier or speakers.

a) Switching on

• Turn the volume control of the connected amplifier down completely.
• Press the POWER switch (1) to switch on the player.
• Then switch on any connected audio devices and last the amplifier.

b) Inserting a CD

• Select the playback source CD with the button CD/USB/SD (22).
• Press the OPEN/CLOSE button (18) and place a CD on the CD tray (27) with the printed side facing up-
wards.
• Press OPEN/CLOSE button (18) again. The CD tray (27) is closed again.
• The CD is read.
• Then, the device automatically sets the CUE mark at the beginning of music in the first track and goes into
pause mode. You can now start playback.
The CD cannot be ejected during playback mode. This makes sure that the playback is not interrupted
unintentionally. Before pushing the OPEN/CLOSE button (18), stop playback.
The LED CD (48) lights up when there is no CD in the CD tray.
Never obstruct the movement of the CD tray. Do not force the CD tray into the drive. This dam-
ages the mechanism and leads to malfunctions.
Do not insert any damaged CDs into the player. The high rotational speed may cause it to crack
and damage the device. Do not insert more than one CD.
44