Renkforce CDM-900MUSB Bedienungsanleitung Seite 38

(15/16) PITCH BEND +/- buttons
With these buttons, you can temporarily increase or decrease the playing speed by up to +/-16 %.
(17) Display
The display shows the most important settings and information of the playback medium.
(18) OPEN/CLOSE button
Push this button to eject the CD. The CD cannot be ejected during CD playback.
(19) VINYL button
Activate the SCRATCH function (VINYL function) with this button. You can now scratch the track selected
with the JOG wheel (2) in PLAY or PAUSE mode like on a record player.
(20) REVERSE button
When the REVERSE function is activated, the track is played backwards.
(21) PITCH slider
Use the PITCH slider to change the playback speed. The slider only has an effect if the pitch function has
been activated using the PITCH (14) button.
(22) USB/SD button
Use this button to select the playback carrier (source) CD, USB or SD.
(23) TAP button
Press this button in the rhythm of the music. The display shows the beats per minute (BPM)on the right.
(24) USB connection
Insert the USB storage medium here.
(25) SD connection
Insert the SD storage medium here.
(26) HEADPHONE connection
Connection socket for stereo headphones (6.3mm jack plug).
(27) CD tray
Put a CD for playback in here. Always insert the CD with the printed side up.
(28) CUE switch
Select the signal for the headphones with this switch.
(29) Input selection switch
The input selection switch chooses between the individual inputs (signal sources) of the channel. Depend-
ing on switch position, the associated signal source is played back via this mixer channel.
38