Temperature (Only For Centrifuge With Refrigeration); Programming; Unchangeable Programs; Program Input / Changes - Hettich ROTINA 380 R Bedienungsanleitung

EN
14.5

Temperature (only for centrifuge with refrigeration)

The temperature can be entered in degrees Celsius (°C) or in degrees Fahrenheit (°F). For setting the
temperature unit, see chapter "Setting the temperature unit".
•
Press the key. The following parameters are displayed: T/°C or T/°F.
T/°C
•
Use the adjusting knob
•
Press the key, to have the settings applied to the display.
START
15

Programming

If parameters are changed, the program place number is displayed in parentheses (). This means that the
centrifugation data in the display no longer corresponds to the centrifugation data from the program place that
has been saved.
15.1

Unchangeable programs

(for type 1701-30 only)
Programs 1 to 4 are preconfigured and cannot be changed.
When attempting to save data at the program places 1 to 4, "Protected !!" is displayed and the data is not
saved.
During the program call, "+" indicates that this data can't be changed for program places 1 to 4.
PROG 1
RAD 155
RCF 200
RPM 1074
Running 2:15
time
9
0
15.2

Program input / changes

•
Set the parameters you want (see chapter "Entering centrifugation parameters").
•
Press the key as often as necessary until the STO parameter is shown.
PROG
•
Use the adjusting knob
•
key to have the settings saved to the program place you want. Briefly, Program store ... is
Press the
START
displayed as confirmation.
The previous data in the program position is overwritten during saving.
15.3

Calling up programs

•
Press the key. The parameters RCL is displayed.
PROG
•
Use the adjusting knob
•
Press the key. Briefly, Program recall ... is displayed as confirmation.
START
The centrifugation data of the selected program place is shown.
15.4

Automatic temporary storage

The program place 0 serves as temporary storage for centrifugation data of the last centrifugation run that took place.
No programs can be saved at this program place.
After every start to a centrifugation run, the centrifugation data that is used for the run is automatically saved at
program place "0" and can be accessed there.
32/105
to set the value you want.
PROG 2
RAD 155
RCF 800
RPM 2149
Running 10:15
time
9
6
to set the program place you want.
to set the program place you want.
PROG 3
RAD 155
RCF 600
RPM 1861
Running 10:15
time
9
6
PROG 4
RAD 155
RCF 600
RPM 1861
Running 5:15
time
9
6