H) Performing Dcf Reception; I) Performing The Outdoor Sensor Reception Attempt; J) Battery Replacement; Battery Change - Conrad Electronic CPA601 Bedienungsanleitung

h) Performing a DCF reception attempt

For more information about DCF reception, see chapters 9 and 14.
To start a manual DCF reception attempt, press the button "" for two seconds until the DCF
symbol blinks on the top right of the display. Wait a few minutes and do not move the projection
clock during this time.

i) Performing the outdoor sensor reception attempt

To search manually for the outdoor sensors (e.g. in case of a battery change in the outdoor
sensor), press the button "CHANNEL" for two seconds until the radio signal blinks on the
bottom right of the display.
The reception attempt may take up to two minutes. Do not move the projection clock and the
outdoor sensor during that time.

If you use more than one outdoor sensor, each outdoor sensor must be
registered on a separate transmission channel (see chapter 8).
j) Battery change
Projection radio clock
If a battery empty symbol "
weak and should be exchanged.
Outdoor sensor
If a battery empty symbol "
sensor, the batteries are weak and should be exchanged.
52
" appears on the projection clock (top right), the batteries are
" appears on the bottom right of the display for the outdoor