Operation; A) Time Projection - Conrad Electronic CPA601 Bedienungsanleitung

11. Operation

a) Time projection

Via the integrated projector it is possible to project the time onto the ceiling. The projector
system can be rotated, the indication can also be mirrored.
The projection can be continuous (only if the provided plug-in power unit is used!) or be
activated by pressing a button (e.g. during the night).

Please be aware that the readability of the time projected is reduced in daylight.
With the adjuster adapter (I), you can turn the projector system and focus the display.

The adjustment adapter is plugged into the rear in the middle of the keypad (so
it cannot get lost) and can easily be removed. After use, replace the adjustment
adapter in the support on the rear.
The side with the teeth serves to twist or swivel the
projector system. Do not use any force! The swivel
range is not too large!
The smooth side serves to focus the projection
depending on the distance between the radio
projection clock and the room ceiling.
If the slider (J) on the inside of the battery compartment is set to "AUTO", the time is first
projected when you press on the top of the projection clock.

The button is located on the bottom in the base, therefore it is easy to start the
projection at night because you don't have to look for the button in the dark.
If the slider (J) is set to "BACKLIGHT/PROJECTION", the time is projected permanently (only
when using the supplied power pack unit).
With the button " " on the back of the projection clock, the projection can be mirrored.
47