• With the button "" or "", turn the DCF reception OFF or ON.
This lets you operate the projection clock in case of bad reception or outside the signal range,
e.g. on holiday.
When the DCF reception is off, you have to set the time by hand.
• By pressing the "CLOCK" button again you will exit the setting mode.
If you do not press any buttons for some time, you also exit setup mode.
d) Switching between seconds and weekday display
If you briefly press the button "CLOCK", the display switches from the display of the seconds
to the weekday (abbreviations in 5 languages, see chapter 11. c).
e) Switching between alarm time and date display
/
Press the "
sequence (day/month or month/day) as described in chapter 11 c).
f) Display indoor/outdoor temperature
Briefly press the button "CHANNEL" to switch between the following displays:
• Indoor temperature
• Automatic change between the indoor temperature and the 3 outdoor sensors (only
available sensors are displayed); a rotating arrow icon shows the automatic change.
• Outdoor temperature of outdoor sensor 1
• Outdoor temperature of outdoor sensor 2
• Outdoor temperature of outdoor sensor 3
The transmission channel of the outdoor sensor can be set as described in
chapter 8.
If lines appear on the bottom right of the display, the corresponding outdoor
sensor is not available or its battery spent.
50
" button as many times until the date is shown on the display. Set the