A manual search for available outdoor sensors (e.g. for a newly added sensor
or in case of a battery change) is possible later on with the button "CHANNEL";
for this purpose, press this button for approx. 2 seconds.
• If you want to use the power pack unit (which is the only way to ensure a permanent
background illumination of the display or a permanent projection of the time), connect the
round plug of the supplied power pack unit with the connection socket on the bottom of the
battery compartment.
Make sure that the round plug is completely inserted into the socket.
• Connect the power pack unit with the mains voltage and insert it into a wall outlet (230V~/
50Hz).
• Close the battery compartment of the radio projection clock.
• After the search for outdoor sensors (approx. 2 minutes), the radio projection clock starts
locating the DCF signal. For this purpose, see the next chapter .
43