Conrad ReFLEX 200 multi Bedienungsanleitung Seite 15

§
Use the right rotary switch to set the charging current for the accumulator. The
nominal capacity of the accumulator pack should be known for the charging
current setting. It is usually printed on the accumulators.
Example:
The accumulator pack consists of mignon cells with a capacity of
500mAh. The value 500 mAh is equivalent to this C rate: C = 0.5A.
Set the current selection switch to 1A accordingly for 2C charge.
§
Now connect the accumulator pack to the charging sockets, taking care
to ensure correct polarity.
Note:
In order to protect the charger and the accumulators, the ReFLEX 200 multi has
been fitted with a protection device against reverse polarity.
§
The device now automatically starts the charging process. The green
charging LED lights up and, at the same time, the yellow impulse LED starts
to flash approx. once a second.
§
When the impulse LED starts to flash only once every 20-30 seconds, the
accumulator is charged (see also chapter 4, Functional and performance
description).
15